Base kit for vertical antenna
All the material necessary to install on the ground an insulated, tilting, vertical antenna capable of having 64 radials attached. On OFFER (10% reduction).
Pack content
Base intended for the erection of a tilting vertical antenna or tubular mast from 30 to 52 mm diameter.
Stainless 100mm long Ø 10 mm bolts and 2 broad nylon washers, 60 mm diameter, 3 mm thick.
30 x 30 cm, 3mm thick aluminium plates, drilled to suit our 2 models of base for vertical antenna/mast, and for the fixing of the whole unit and 64 radials (or less).
4 x 30 cm long by 8 mm diameter steel stakes for fixing a base support plate to the ground.
Thick aluminium bracket equipped with a teflon insulated SO-239 connector.
64 stainless steel screws, 4.2mm diameter, for attaching the radials of a vertical antenna.
Insulator in reinforced polyethylene consisting of 3 tubes which adapt for various diameters of vertical antenna.
64 x 4 mm eye terminals for wire up to 2.5 mm² for attaching the radials of a vertical antenna. Tinned copper.
